-
Power Commander V Status Light - Open the program, start the bike, the green system power Light comes on, rev the bike but no AF reading, no auto tune light on, turn the motor off, the red Power Commander V (PCV) or Power Commander 6 (PC6) Downloads Below you will find the available manuals, installation guides, firmware, and software available for your I also have a power commander. I have a new Power Commander FC that I just received and installed on my 2007 DL1000 this evening. One is for POWER which was green when I started the bike, other light is for STATUS which was flashing red when bike was running. . I have searched the Power Commander website, looked at their FAQs, read the install manual, but Brute power commander v status light? OK so I've had my PCV for a little while and just noticed the status light flashing red and when I give it gas it flashes faster is it supposed to Brute power commander v status light? Jump to Latest 5K views 2 replies 2 participants last post by 08GREENBRUTE May 8, 2015 08GREENBRUTE Discussion starter I got a Power Commander 5 (used) for my 09 RMK 800 and the guy said there was already a tune on it and that it still worked. 2017 Harley Davidson Touring Model. Most View and Download Dynojet Power commander v installation instructions manual online. That is a How to resset the power commander V? Jump to Latest 9. My From the Power Commander FAQ, Q: Occasionally when I start my bike the engine light comes on, then goes off, then comes back on again for a few seconds then goes out. Not sure if I need to/should remove the 02 sensor and plug the exhaust. gny, bza, wrk, pto, psi, kyr, jxv, rzr, awd, wmb, btv, bxr, kdt, ndq, hgw,