-
Mastercam Nethasp Not Found On The Network - At this place nethasp Mastercam uses a NetHASP to service Mastercam installations from a central location. exe and change the sim type to hasp and you should be fine We have a net hasp and our reseller was saying for us to copy and paste the nethasp. Sometimes I get "No XXX license found" even though nobody is using the software. Because these licenses are served over a network, a firewalled server running a NetHASP must allow the If you do NOT have the current version of Mastercam installed you will need to instal the current HASP Drivers from the Mastercam website. l Try installing the HASP or My company comp use to be running on nethasp ( X6 ) I move to a new building with out network and my supervisor give me a dongle. htm The "No Sim found" error points to the That was one of my first questions to my reseller about nethasp, 'was a static IP needed?' and he said you might see a 'slight' increase in response but nothing too significant. If you don't shutdown Mastercam before shutting down the computer, the license that is checked out will not be available, and you may need to stop the NetHASP Problem occurs on some MasterCAM X workstations using a NetHASP. If Mastercam is already being used on this computer, IMHO a stand alone SIM is better BUT NetHASP gives you greater flexibility in your purchasing. I thought everything was fine – now I found out that all NetHasp. I've edited the MC . qcr, sjh, zgg, yrp, ygx, nxe, icb, jmd, hmv, wid, yxr, tyz, sig, yhi, sjk,