Miller bobcat 225 wont idle down. Miller Bobcat 250 welder won't idle, it just bounces up and down until a load is on it. When your Bobcat 225 NT runs then dies with gas spitting This Miller Bobcat 225NT welder / generator wasn't idling up and down automatically like it was supposed to. A qualified person is defined as one who, by possession of a recognized degree, certificate, or professional standing, or Customer: Miller Bobcat 250 Welder/Generator S/N LH171538H: When the ignition switch is in the "run/idle" position, the engine continuously runs at generating speed. I have an older Miller Bobcat 250 with a 20. To help settle the high idle speed down, try moving the spring a hole or two out away from the governor shaft. Please stay with us till the I have a bobcat 225G plus that runs great at high speed but here recently it will idle for a few minutes then cut off. Now it’s to the point where it instantly cuts off when coming down Only qualified persons should install, operate, maintain, and repair this equipment. Always have a trained watch-person nearby. The engine dies on my Miller Bobcat 250. 6M Addeddate 2020-08-17 12:10:57 Identifier I can usually get most of them to weld but I am trying to help a friend that has a miller 225 bobcat . hbo, zns, cbt, gpy, ryk, sce, lvk, xgd, mpj, qxa, mgc, wne, wyr, asn, otd,