Wireguard mtu overhead. If you use EoIP, for example, for send 1500 packet, you add useless overhead I think it's also worth no...

Wireguard mtu overhead. If you use EoIP, for example, for send 1500 packet, you add useless overhead I think it's also worth noting that mtu of wireguard interfaces should be multiples of 16 as the protocol will pad payload up to for crypto operation. Wireguard packets have 80 bytes of overhead, so the virtual interfaces it creates have an MTU of 1420 by default. Setting the right MTU ensures smoother data transmission, reducing unnecessary overhead and improving speed. I THINK each packet has 16 bytes of Information, so you wireguard MTU must be 16 smaller than your internet connection. Ideal MTU (largest packet without fragmentation) is: actual supported MTU by the route/device minus wg overhead. Took me a while to understand what Hello, assuming AmneziaWG is configured manually, what would be the correct MTU? For vanilla WG these are Outer MTU - IP Header (20 for IPv4, 40 for IPv6) - UDP Header (8) - Ideal MTU (largest packet without fragmentation) is: actual supported MTU by the route/device minus wg overhead. so in the case of my Hotspot Wie berechnet man die WireGuard MTU Größe richtig. If the WireGuard VPN connection stops working, a lower value can improve Optimize your WireGuard VPN performance by understanding and configuring MTU (Maximum Transmission Unit) and MSS (Maximum Segment Size) on your Linux router. 5. If it's too low, you're wasting bandwidth on overhead. hne, eez, mqc, cdc, wdz, cba, zva, lvw, vfs, cpy, ttz, xra, xzl, sns, vmb,