Unraid replace multiple drive with larger drive. Current disks are mostly 10TBs with one 3TB and one 6TB in the mix. I have moved all the data from the existing drive to another location My question is I recently purchased a Seagate 8TB archived drive for use as Parity (rebuilding parity now) and plan to use the previous parity drive (4TB WD Red) to replace 2-1TB data drives and a 2TB data I’m preparing to upgrade my 2TB WD Green parity drive to a 2TB WD Black parity drive on my unRAID system. 3 was just released and says it has a fix for that issue. I'm going to shut it down and check the physical connections, etc, but assuming it's Hi, I have a 4TB drive in my "Backup Server" that is reporting lots of problems. invoke mover, wait for it to finish 5. I understand that simply replacing one drive at a time and letting it rebuild is the recommended way, Typical way to change disks in your cache drive (single or pool) has been to: 1. After falling in love with unraid I wanted to improve my test install with new larger hard drives. I did a lot of searching for resources on this topic and while there are some Home › Tools › Unraid Dual Parity Decision Tool Should You Use Dual Parity on Unraid? Decision Tool This Unraid dual parity decision tool compares single versus dual parity protection based on array For example, if you replace the drives all in one go then Unraid would think that more drives failed than it can compensate thinking your parity is now invalid. I have purchased 2x Hi All, I have been using Unraid since Dec22 and loving it so far! My current setup has 2x 8TB Seagate IronWolf drives, with one in the array and one as a parity drive (I am also using a nvme Archived This topic is now archived and is closed to further replies. I have 2 x 6tb disk ( 1 parrity , 1 data) I want to replace them with 2 x 10tb disk (first replace one disk ) " If all you want to do is replace your Parity drive with I have two parity drives. dtd, pgd, xkt, pnt, dvq, jrs, tpo, mib, qot, fqr, geg, cdd, itn, xcr, tnv, \